Gone are the removeable wood inserts used in the first generation, replaced by a
permanent brass insert that dramatically simplifies file replacement. Additionally, you can switch files at any time without
losing the rake angle you set.
The key to a well sharpened handsaw is accurate and consistent tooth geometry. Two of the most important elements of saw tooth geometry are the rake and fleam angles. the RakeMaker I will improve the speed and accuracy of beginner and expert saw sharpeners alike.
The RakeMaker I fits over the end of almost any triangular saw file (I use it for files ranging from needle files for sharpening 18 ppi dovetail saws to 7 inch slim taper files for the largest rip saws), providing visual and tactile references that help you achieve and maintain accurate and consistent rake angles.
The RakeMaker I takes advantage of our innate ability to discern parallel and horizontal lines. By magnifying the angle of the file, even small deviations from the target rake angle are readily apparent.
While saw sharpeners have used a "stick on a file" for years to control rake angles while sharpening, the RakeMaker I takes that concept to the next level. By adding further precision, it is possible to file your saws more accurately and consistently, leading to more predictable sawing characteristics.
If you file from both sides of the saw, the rake angle can be quickly and accurately switched. And because it is so easily adjustable, filing progressive rake is a simple matter.
Further, because the body is made of wood, the RakeMaker I is easily customized. One such modification is to trim the ends of the body (see instructions, page 5) to the fleam angle that you most commonly use, allowing both rake and fleam to be regulated with the RakeMaker I.
Made in the USA of stainless steel, brass, and tropical hardwood. Fully warranted for one year.
The body is made of chakte viga, a beautiful, dense hardwood from southern Mexico. Stainless steel and brass hardware. Three inches long.
Shipping within the US and select other countries will be calculated during checkout. For shipping charges to other countries, please contact me before ordering.
DISCONTINUED RakeMaker I, complete - $29.50 each DISCONTINUED
For those who modify the body to serve as a fleam guide, and need several different angles, the RakeMaker I body is available separately. Made of chakte viga, a beautiful, dense hardwood from southern Mexico. Three inches long.
Shipping within the US and select other countries will be calculated during checkout. For shipping charges to other countries, please contact me before ordering.
DISCONTINUED RakeMaker I, body only - $9.50 each DISCONTINUED
RakeMaker I |